12. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
13. Install the battery.
14. Follow the procedure in after working inside your computer.
Power button with fingerprint reader
Removing the power button board with fingerprint reader
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the battery.
3. Remove the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
4. Remove the keyboard.
5. Remove the base cover.
6. Remove the fan.
7. Remove the heat-sink (UMA) or heat-sink (discrete).
8. Remove the Wi-Fi I/O board.
9. Remove the WLAN card.
10. Remove the WWAN card.
11. Remove the dock I/O board.
12. Remove the rear I/O board.
13. Remove the system board.
14. Remove the right Type-C daughterboard.
About this task
The following images indicate the location of the power button board with fingerprint reader and provide a visual representation
of the removal procedure.
86
Removing and installing components
To Next Page
Loading...
