Next steps
1. Install the base cover.
2. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
3. Install the battery.
4. Follow the procedure in after working inside your computer.
Heat sink
Removing the heat-sink
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the battery.
3. Remove the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
4. Remove the base cover.
5. Remove the Wi-Fi I/O board.
6. Remove the WLAN.
7. Remove the dock I/O board.
About this task
The following images indicate the location of the heat-sink and provide a visual representation of the removal procedure.
Steps
1. Remove the three (M2x3.5) and four (M2x6) screws (in reverse order, 7->6->5->4->3->2->1) that secure the heat-sink to
the system board.
2. Lift the heat-sink from the system chassis.
Removing and installing components
61
To Next Page
Loading...
