5. Remove the base cover.
6. Remove the fan.
7. Remove the heat-sink (UMA) or heat-sink (discrete).
8. Remove the Wi-Fi I/O board.
9. Remove the WLAN card.
10. Remove the WWAN card.
11. Remove the dock I/O board.
12. Remove the rear I/O board.
13. Remove the system board.
14. Remove the display assembly.
15. Remove the display bezel.
16. Remove the camera.
17. Remove the display hinges.
About this task
The following images indicate the location of the display cable and provide a visual representation of the removal procedure.
Steps
Peel the adhesive tape off the eDP cable adhered to the display cover.
Installing the display cable
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing components
101
To Next Page
Loading...
