Steps
1. Remove the (M2x3.5) screw that secures the flat printed cable holder to the left Type-C daughterboard.
2. Disconnect the flat printed cable from its connector on the left Type-C daughterboard.
3. Disconnect the daughterboard cable from its connector on the left Type-C daughterboard.
4. Remove the four (M2x3.5) screws that secure the left Type-C daughterboard to the system chassis.
5. Lift the left Type-C daughterboard from the system chassis.
Installing the left Type-C daughterboard
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the left Type-C daughterboard and provides a visual representation of the
installation procedure.
Removing and installing components
81
To Next Page
Loading...
