Camera
Removing the camera
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the battery.
3. Remove the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
4. Remove the keyboard.
5. Remove the base cover.
6. Remove the fan.
7. Remove the heat-sink (UMA) or heat-sink (discrete).
8. Remove the Wi-Fi I/O board.
9. Remove the WLAN card.
10. Remove the WWAN card.
11. Remove the dock I/O board.
12. Remove the rear I/O board.
13. Remove the system board.
14. Remove the display assembly.
15. Remove the display bezel.
About this task
The following images indicate the location of the camera and provide a visual representation of the removal procedure.
Steps
1. Peel the tape and disconnect the eDP cable on the camera module.
2. Lift and remove the camera module from the display panel.
Installing the camera
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing components
97
To Next Page
Loading...
