Steps
1. Connect the touch cable to its connector on the touch screen board.
2. Connect the eDP cable to its connector on the LCD module and flip the display bezel on the display assembly.
3. Align the display bezel with the display assembly. Gently snap the display bezel into place.
4. In sequential order, replace the 11 (M2.5x6, T8) blue screws that secure the display bezel to the display assembly.
NOTE:
Ensure that the display assembly is placed on a flat surface when replacing the screws to avoid light leakage
from LCD. This must be done when part twisting assembly screw torque: 3 kgf-cm.
5. Replace the 4 (M2.5x6, T8)yellow epoxy screws to secure the display bezel to the display assembly.
Next steps
1. Install the display assembly.
2. Install the system board.
3. Install the heat-sink (UMA) or heat-sink (discrete).
4. Install the fan.
5. Install the rear I/O board.
6. Install the dock I/O board.
7. Install the WWAN card.
8. Install the WLAN card.
9. Install the Wi-Fi I/O board.
10. Install the base cover.
11. Install the keyboard.
12. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
13. Install the battery.
14. Follow the procedure in after working inside your computer.
96
Removing and installing components
To Next Page
Loading...
