Next steps
1. Install the base cover.
2. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
3. Install the battery.
4. Follow the procedure in after working inside your computer.
Dock I/O board
Removing the dock I/O board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the battery.
3. Remove the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
4. Remove the base cover.
5. Remove the Wi-Fi I/O board.
6. Remove the WLAN card.
About this task
The following images indicate the location of the dock I/O board and provide a visual representation of the removal procedure.
50
Removing and installing components
To Next Page
Loading...
