Next steps
1. Install the display cable.
2. Install the display hinges.
3. Install the camera.
4. Install the display bezel.
5. Install the display assembly.
6. Install the system board.
7. Install the heat-sink (UMA) or heat-sink (discrete).
8. Install the fan.
9. Install the rear I/O board.
10. Install the dock I/O board.
11. Install the WWAN card.
12. Install the WLAN card.
13. Install the Wi-Fi I/O board.
14. Install the base cover.
15. Install the keyboard.
16. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
17. Install the battery.
18. Follow the procedure in after working inside your computer.
Display back-cover
Removing the display back cover
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the battery.
3. Remove the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
4. Remove the keyboard.
5. Remove the base cover.
6. Remove the Wi-Fi I/O board.
7. Remove the WLAN card.
8. Remove the WWAN card.
9. Remove the dock I/O board.
10. Remove the rear I/O board.
11. Remove the fan.
12. Remove the heat-sink (UMA) or heat-sink (discrete).
13. Remove the system board.
14. Remove the display assembly.
15. Remove the display bezel.
16. Remove the camera.
17. Remove the display hinges.
18. Remove the display cable.
About this task
The following images indicate the location of the display back cover and provide a visual representation of the removal
procedure.
Removing and installing components
107
To Next Page
Loading...
