Steps
1. Place the left I/O board and connect the flexible printed cable to its connector.
2. Flip the left I/O board and replace the two (M2x3.5) screws to secure it to the system chassis.
3. Adhere the adhesive on the left I/O board and connect the speaker cable.
Next steps
1. Install the base cover.
2. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
3. Install the battery.
4. Follow the procedure in after working inside your computer.
Speakers
Removing the speakers
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the battery.
3. Remove the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
4. Remove the base cover.
5. Remove the LED board.
About this task
The following images indicate the location of the speakers and provide a visual representation of the removal procedure.
56
Removing and installing components
To Next Page
Loading...
