Installing the palmrest assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the palmrest assembly and provides a visual representation of the installation
procedure.
Steps
After performing the succeeding steps, you are left with the palmrest assembly.
Next steps
1. Install the touchpad buttons.
2. Install the touchpad.
3. Install the power button board with finger print reader.
4. Install the power button board.
5. Install the display assembly.
6. Install the system board.
7. Install the heat-sink (UMA) or heat-sink (discrete).
8. Install the fan.
9. Install the rear I/O board.
10. Install the dock I/O board.
11. Install the WWAN card.
12. Install the WLAN card.
13. Install the Wi-Fi I/O board.
14. Install the base cover.
15. Install the keyboard.
16. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
17. Install the battery.
18. Follow the procedure in after working inside your computer.
Removing and installing components
115
To Next Page
Loading...
