Table 15. System setup options—Display menu (continued)
Display
By default, the option is enabled.
Full Screen Logo Enable or disable full screen logo.
By default, the option is not enabled.
Limit Panel Brightness to 50% Enable or disable the panel brightness limit to 50%.
By default, the option is not enabled.
Table 16. System setup options—Connection menu
Connection
Network Controller Configuration
Integrated NIC This option controls the on-board LAN controller.
By default, the Enabled with PXE option is enabled.
Onboard Unmanaged NIC This option controls the on-board USB LAN controller.
By default, the Enabled option is selected.
Wireless Device Enable
WWAN/GPS Enable or disable the internal WWAN/GPS device
By default, the option enabled.
WWAN Bus Mode Set the interface type of the Wireless Wan (WWAN) card.
By default, the Bus Mode USB option is enabled.
WLAN Enable or disable the internal WLAN device.
By default, the option enabled.
Bluetooth Enable or disable the internal Bluetooth device
By default, the option enabled.
Contactless smartcard/NFC Enable or disable the internal Contactless smartcard/NFC device
By default, the option enabled.
Enable UEFI Network Stack Enable or disable UEFI Network Stack and controls the on-board LAN
Controller.
By default, the Auto Enabled option is selected.
Wireless Radio Control
Control WLAN radio Sense the connection of the system to a wired network and subsequently
disable the selected wireless radios (WLAN).
By default, the option is disabled.
Control WWAN radio Sense the connection of the system to a wired network and subsequently
disable the selected wireless radios (WWAN).
By default, the option is disabled.
HTTPs Boot Feature
HTTPs Boot Enable or disable the HTTPs Boot feature.
By default, the Auto Mode option is enabled.
HTTPs Boot Mode With Auto Mode, the HTTPs Boot extracts Boot URL from the DHCP. With
Manual Mode, the HTTPs Boot reads Boot URL from the user-provided data.
By default, the Auto Mode option is enabled.
122 BIOS setup
To Next Page
Loading...
