Steps
1. Place the speakers on the system chassis.
2. Replace the two (M2x3.5) and two (M2.5x6, T8) epoxy screws to secure the speakers to the system chassis.
3. Route the cable using the routing channel and connect the speaker cable to the connector on the left I/O board.
Next steps
1. Install the LED board.
2. Install the base cover.
3. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
4. Install the battery.
5. Follow the procedure in after working inside your computer.
58
Removing and installing components
To Next Page
Loading...
