Steps
1.
NOTE:
The following epoxy screw locations will require additional focus. These screws are difficult to remove and there
may be damage during the removal process. To prevent damage to the screws and surrounding plastics, please use the
correct screwdriver for each screw type.
Remove the two epoxy cap (4-40x6.5) screws that secure the serial RS-232 port to the system chassis.
To remove the epoxy cap screws use a 5.5 mm hex socket wrench.
2. Remove the serial RS-232 port from the system chassis.
70
Removing and installing components
To Next Page
Loading...
