Steps
1. Place the power button with fingerprint-reader board on the system chassis.
2. Place the power button with fingerprint reader bracket on the fingerprint-reader board.
3. Replace the three (M2x3.5) screws that secure the power button with fingerprint reader bracket to the system chassis.
4. Connect the fingerprint reader cable to its connector on the power button board.
Next steps
1. Install the right Type-C daughterboard.
2. Install the system board.
3. Install the rear I/O board.
4. Install the dock I/O board.
5. Install the WWAN card.
6. Install the WLAN card.
7. Install the Wi-Fi I/O board.
8. Install the heat-sink (UMA) or heat-sink (discrete).
9. Install the fan.
10. Install the base cover.
11. Install the keyboard.
12. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
88
Removing and installing components
To Next Page
Loading...
