System Setup Program A-5
Parallel Port Configures system’s built-in parallel port. The
port’s I/O address may be set to 378h (default),
278h
,
or 3BCh
.
Otherwise, the port may be
disabled.
Parallel Mode Controls whether system’s built-in parallel port
acts as an AT-compatible (unidirectional) or
PS/2-compatible (bidirectional) port. The sys-
tem also supports ECP mode for Windows 95.
IDE Hard Disk Enables system’s built-in EIDE hard-disk drive
interface.
Diskette Enables system’s built-in diskette drive
controller.
Speaker Enables built-in speaker.
Microprocessor Displays type of microprocessor installed.
Level 2 Cache Displays size of the integrated cache.
Video Memory Displays amount of video memory on the sys-
tem board.
System Memory Displays entire amount of installed memory
detected in system, except for memory on EMS
expansion cards.
Service Tag Displays system’s five-character service tag
number.
Asset Tag Displays the asset tag number if one is
assigned.
Table A-1. System Setup Categories
(continued)
Category Function
To Next Page
Loading...
