Configuring Switching Information 433
•softphonevoice
• videoconferencing
• streammingvideo
• videosignalling
–
Vlan Id
— Specifies the VLAN ID associated with a particular policy type.
–
Priority
— Specifies the priority associated with a particular policy type.
–
DSCP
— Specifies the DSCP associated with a particular policy type.
–
Unknown Bit Status
— Specifies the unknown bit associated with a particular policy type.
–
Tagged Bit Status
— Specifies the tagged bit associated with a particular policy type.
•
Inventory
— If an inventory TLV is present in LLDP frames, the following information displays:
–
Hardware Revisions
— Specifies the hardware version of the remote device.
–
Firmware Revisions
— Specifies the firmware version of the remote device.
–
Software Revisions
— Specifies the software version of the remote device.
–
Serial Number
— Specifies the serial number of the remote device.
–
Manufacturer Name
— Specifies the manufacturer’s name of the remote device.
–
Model Name
— Specifies the model name of the remote device.
–
Asset ID
— Specifies the asset ID of the remote device.
•
Location Information
— If a location TLV is present in LLDP frames, the following information
displays:
–
Sub Type
— Specifies type of location information.
–
Location Information
— Specifies the location information as a string for given type of location
id.
•
Extended PoE
— Specifies if remote device is a PoE device.
–
Device Type
— Specifies remote device's PoE device type connected to this port.
•
Extended PoE PSE
— If an extended PSE TLV is received in the LLDP frame on this port, the
following information displays:
–
Available
— Specifies the remote ports PSE power value in tenths of watts.
–
Source
— Specifies the remote port’s PSE power source.
–
Priority
— Specifies the remote ports PSE power priority.
•
Extended PoE PD
— If an extended PD TLV is received in the LLDP frame on this port, the following
information displays:
–
Required
— Specifies the remote port's PD power requirement.
–
Source
— Specifies the remote port's power source.
–
Priority
— Specifies the remote port's PD power priority.
To Next Page
Loading...
