Configuring Routing 605
Creating a New Loopback (IPv6)
1.
Open the
Loopbacks Configuration
page.
2.
Select
Create
from the
Loopback
drop-down menu.
3.
Specify an ID to use in the
Loopback ID
field.
4.
Click Apply Changes.
The Loopback ID field goes away, and the remaining loopback fields display.
Figure 9-58. Loopbacks Configuration - IPv6 Entry
5.
Choose
IPv6
from the drop-down box in the
Protocol
field.
6.
Add the
IPv6 Address
.
7.
Enter desired values in the remaining fields.
8.
Click
Submit
.
The new loopback is saved, and the device is updated.
Configuring an Existing Loopback
1.
Open the
Loopback Configuration
page.
2.
Specify the loopback to configure in the
Loopback
drop-down menu.
3.
Change field values as desired in the remaining fields.
4.
Click
Apply Changes
.
The new configuration is saved, and the device is updated.
Removing a Loopback
1.
Open the
Loopback Configuration
page.
To Next Page
Loading...
