Dell S4048-ON - Page 282

Fields Description
Application Priority TLV: Local ISCSI Priority Map Priority bitmap used by local DCBx port in ISCSI advertisements in
application priority TLVs.
Application Priority TLV: Remote FCOE Priority Map Status of FCoE advertisements in application priority TLVs from
remote peer port: enabled or disabled.
Application Priority TLV: Remote ISCSI Priority Map Status of iSCSI advertisements in application priority TLVs from
remote peer port: enabled or disabled.
PFC TLV Statistics: Input TLV pkts Number of PFC TLVs received.
PFC TLV Statistics: Output TLV pkts Number of PFC TLVs transmitted.
PFC TLV Statistics: Error pkts Number of PFC error packets received.
PFC TLV Statistics: Pause Tx pkts Number of PFC pause frames transmitted.
PFC TLV Statistics: Pause Rx pkts Number of PFC pause frames received
The following example shows the show interface pfc statistics command.
Dell#show interfaces te 1/1 pfc statistics
Interface TenGigabitEthernet 1/1
Interface Priority Rx XOFF Frames Rx Total Frames Tx Total Frames
-----------------------------------------------------------------------------------------------
Te 1/1 P0 0 0 0
Te 1/1 P1 0 0 0
Te 1/1 P2 0 0 0
Te 1/1 P3 0 0 0
Te 1/1 P4 0 0 0
Te 1/1 P5 0 0 0
Te 1/1 P6 0 0 0
Te 1/1 P7 0 0 0
The following example shows the show interface ets summary command.
Dell(conf)#do show interfaces te 1/1 ets summary
Interface TenGigabitEthernet 1/1
Max Supported TC is 4
Number of Traffic Classes is 8
Admin mode is on
Admin Parameters :
------------------
Admin is enabled
PG-grp Priority# BW-% BW-COMMITTED BW-PEAK TSA
% Rate(Mbps) Burst(KB) Rate(Mbps) Burst(KB)
----------------------------------------------------------------------------------
0 3 25 - - - - ETS
1 4 25 - - - - ETS
2 0,1,2,5,6,7 50 - - - - ETS
3 - - - - - -
4 - - - - - -
5 - - - - - -
6 - - - - - -
7 - - - - - -
Remote Parameters :
-------------------
Remote is disabled
Local Parameters :
------------------
Local is enabled
282
Data Center Bridging (DCB)