Dion-Ag F41 - Check List; Pre-Season Checks

10
PRE-SEASON CHECKS
Check condition of knives and shearbar. Check that knives and shearbar are set at zero
clearance.
Check tension of belts and chains. Make sure sheaves and sprockets are correctly
aligned.
Check all adjustable components for correct setting. Make sure adjustments are
correctly done (fan, etc)
Check tire pressure. See specications.
Check wheel rim bolt torque. See Specications.
Perform complete lubrication and servicing of the machine. Make sure all grease ttings
are in place and taking grease properly. Check gearbox and transmission uid levels.
Look for loose or missing bolts and parts.
Run the machine in a stationary position at half-speed for a short period of time.
Shut off tractor engine. Make sure all moving parts have stopped, then inspect
bearings for over-heating, excessive wear, or loose anges and lock collars.
Check metal detection system for proper operation (if installed on machine). Always
service metal detector when tractor engine is switched off.
Make sure the proper operating adjustments have been made for current crop
conditions.
Make sure SMV emblem (Slow Moving Vehicle) is in good condition and visible.
Make sure all safety shields are installed. Review Safety Precautions.
Check parts for wear (paddles, fan bottom, spout liner, etc.).
CHECK LIST
Manual No. F4117E987E V1.1