93
ADJUSTING THE ATTACHMENT GROUND
CLEARANCE - FIGURE 127
The adjustment of the attachment’s operating height in
respect to the ground is done through a dual-action hy-
draulic cylinder (item 1) with a 3 3/4” (9.5cm) stroke. For
hay attachment, refer to the attachment’s manual.
NOTE: The hydraulic valve handle (item 2) must be open
(in line with the hose) to be in operation mode.
Operate the hydraulic cylinder from your tractor.
2
1
Figure 127
STARTING UP
Always engage the tractor’s power-take-off (PTO) at
low speed in order to prevent the eventual breaking of
the safety bolt on the transmission line.
When Forage Harvester is operated for the rst time, it
is recoended to test the three positions of the feed roll
transmission, namely NEUTRAL, FORWARD and RE-
VERSE.
When the Forage Harvester is equipped with a metal de-
tector, rst use the REVERSE position. Next, operate in
the FORWARD position. See the operating instructions
for the metal detection system. This start-up procedure
is called INITIALIZATION. Look and listen carefully for
any possible anomaly. Operate the spout, deector, hy-
draulic lifting system of the attachments, and that of the
draw bar alignment so that they will all be in their normal
operating position.
OPERATING INSTRUCTIONS
Manual No. F4117E987E V1.1
To Next Page
Loading...