Dion-Ag F41 - Maintenance Procedure for the Cutter Head Bottom Plate Assembly

141
ADJUSTMENTS - MAINTENANCE
MAINTENANCE PROCEDURE FOR THE CUTTER HEAD BOTTOM PLATE ASSEMBLY
FIGURE 209
The bottom plate under the cutter head can be replaced by sliding it backwards.
1. Unbolt the bottom plate by removing the support (item 1), the two 3/8” X 3” lg carriage bolts and 3/8” lock nuts.
2. Remove the half bottom plate (item 3) and the three bolts on each side (item 4).
3. Unbolt the two access doors (item 5) and remove the bolts. The upper cracker roll must also be removed if
necessary.
4. It is now possible to remove the bottom plate by sliding it under the cutter head.
5. Clean thoroughly before sliding in the new bottom plate.
6. Tighten the two 3/8” X 3” lg carriage bolts before tightening the three bolts on each side.
5
3
2
4
1
6
7
Figure 209 Bottom plate assembly under the cutter head
Manual No. F4117E987E V1.1