Dion-Ag F41 - Page 56

56
STEP 6
Secure the solenoid (item 9) to the support plate (item 1)
using the two 1/4” X 3/4” lg ange bolts (items 10) and
two 1/4” nuts (items 11). Position the solenoid so the
chain is well aligned with the pulley’s groove.
9
10
11
1
Figure 66
STEP 7
Connect the ground wire (item 12) using one of the bolts.
The other end will be connected to the negative pole (-)
on the solenoid (item 9).
12
Figure 67
STEP 8
Secure the chain to the hitch lock with a 5/16” X 1 1/4”
lg bolt (item 13), two 5/16” ange nuts (item 14), on each
side of the lock ring. Adjust the chain’s vertical position
using 5/16” at washers (item 15) in order to align it to
the groove in the pulley.
13
14
15
Figure 68
ASSEMBLING INSTRUCTIONS - ELECTRIC QUICK-DISCONNECT HITCH (2017+)
Manual No. F4117E987E V1.1