Dnepr MT9 - Fuel Supply System Removal and Installation; Wheels Removal and Re-Fitting

direction. When doing so, press down the starting pedal with your
foot.
The air filter is to be re-installed in ~ :e\!erse order.
To remove the air ducts of the right- and left-band cylinders, re-
lease the fastening co ll ars. disconn ect the air ducts from lhe carbu-
: ettors and take them ou.t of the ai r filter throat.
The air duds are to be insta ll ed in reverse order.
To remove the exhaust system, do the following:
unscrew lhe nuts of the front stud securing the engine, thus re-
leasing the cl amping collars fastening the silence1 s with the ex-
haust pipe;
unscrew the spec ial nuls of the heads and remove the exhaust
pipes from the cy lind er head channe ls, then unscre\v a1 1d ex tr act
the bolts, secur in g the s il encers to the brackets which are we lded on
lo the frame at the rear point, remove the s il encers .
The exhaust system is lo be re-in sta lled in r everse order, the
collars fastening the exhaust pipes should be the last to be tigh-
tened.
5. REMOVAL AND INSTALLATION OF THE FUEL SUPPLY SYSTEM
I o remove the petrol lank, proceed as follows:
drain petrol from the petrol tank through the petrol supply ho ses
leading to the carburetto rs after f irst removing the hoses from the
carburetto rs union s;
remove the co nnecting ho se of the pe trol tank halv es;
unscrew the bolts of the petrol tank front an d lo we r fastenings
;:~nd, by moving the petrol Lank forward and ra is ing up its rear por-
tion, take down lhe tank aite r first removing Lbe driver's saddle.
The petrol tank is to be re-installed in rever se order .
To
remove the ca rbur e ttor, do the following:
disconnect the air duct;
undo two sc r ews of the throttle chamber cover, take out the
liiroU!es, detach the cab les, r e-insta ll the throttles and the cover,
put in two screws in their original places;
unscrew the nuts securing the carbureltor to the cyl ind er head
~nd remove the carb uretlor.
Re-insta ll the carbu.relto r in r everse order.
6. REMOVAL AND RE-FITTING OF THE WHEELS
T,J remove the front whee l of the motorcycle, proceed as follows:
place the motorcycle on a s upport and raise the front wheel by
putt i ng a backing under the front portion of the motorc yc le frame;
slacken back by severa l turns the nut of the coup ling bolt of the
fork leg left-h and end piece and unscrew the wheel front ax le hav -
ing a left- hand thread;
32