DC-TEC-MAN-CL96_B
DODtec.com
REV 1/9/2024 815-788-5200
Page 89 solutions@dodtec.com
ChemLogic® CL96 Operating Manual
4.3. Re-installing the system exhaust tubing following the labeling placed on the tubing/plugs when they
were disconnected in section 2. For ease of installation start with the lower exhaust tubing/plug
first. Ensure fittings/plugs are fully seated to prevent any exhaust leak.
Images 13: Exterior label for Exhaust locations
Image 14: Example of fitting not fully seated. Image 15: Example of fitting fully seated.
Images 16, 17, and 18: Interior Exhaust tubing/plugs (varies depending on options installed)
4.4. Re-install rear panel.
To Next Page
Loading...