Index
Page 2 DODGE Turbo Diesel
Sen/ice
Procedures 6-3
installation .......... . . .. • • 6-7
Replacement — —
6-3
Specifications .... — -
6-8
Tightening Reference 6-8
Cold
Weather
Starting OB-8
Connecting Rod Bearings - install - 91-16
Coolant OB-12
Coolant - Draining 7-11
Coolant Specifications 9L-10
Rush
the Cooling System - 7-20
Cooling System Components and Flow — 7-2
Cooling System
Malfunctions
- Diagnosis • 7-3
Gauges,
Overfueling and Loading . • 7-9
Pressure
Caps
7-5
Radiator Air Flow — 7-7
Thermostat - 7-8
Water
(Coolant) Pump ................ — ............... — ............................... 7-5
Cooling System Specifications 7-22
Component
Capscrew
Torque Values « 7-22
Cooling System Capacity ' • 7-22
Crankshaft - Cleaning and Inspection — — - 91-21
Crankshaft-Installation -
9I-24
Crankshaft - Removal
9I-20
Crankshaft and
Main
Bearings (Diagnostic Procedures) 9H-4
Crankshaft and
Main
Bearings (Out-of-Chassis Repair) 9C-6
Crankshaft Gear - Replacement 91-23
Crankshaft Grinding - General — — . — ....... —..... 9K-11
Crankshaft
Main
Journal Radius - Regrind • 9K-13
Optional
Procedure - Not to be Used when Thrust Surface
Width
is Reground 9K-13
Preferred Procedure -
All
Main
Journals 9K-13
Crankshaft
Main
Journal Regrind Specifications 9K-11
Crankshaft Repair Tools • — • • 9K-11
Crankshaft Rod Journal Radius - Regrlnd — 9K-14
Optional
Procedure « 9K-15
Preferred Procedure 9K-14
Crankshaft Rod Journal Regrind Specifications • 9K-14
Cup
Plugs - Replacement (Coolant
Passages)
— ........ 7-15
Cup
Plugs - Replacement (Oil
Passages)
• • • 9B-30
Cylinder Block (Diagnostic Procedures) • 9H-5
Cylinder Block - Inspection 91-12
Cylinder Block Repair Procedures — • 9K-3
Cam Bore(s) ... 9K-5
Combustion Deck 9K-4
Cylinder Bore(s) Repair - General — • — • 9K-5
Cylinder Bore(s) - •« • 9K-6
Repair Sleeve Installation • 9K-7
Repair Tools 9K-3
Cylinder
Bores
- De-glaze — ..... — •. 91-13
Cylinder
Head
and Gasket - Installation • 9F-22
Cylinder
Head
and Valve Train
(In-Chassis
Repair) 9C-2
Cylinder
Head
Combustion Deck Inspection and Refacing 9K-17
Cylinder
Head
Overhaul 9F-11
Assembly
of the Cylinder
Head
—. —..... — ... — ........... ..... — ....... 9F-20
Calculating the Grinding
Depth
9F-16
Cleaning and Inspecting the Cylinder
Head
• 9F-12
Cleaning and Inspecting the Valves • 9F-14
Disassembly
of the Cylinder
Head
9F-11
Grinding the Seats — - 9F-16
To Next Page
Loading...
