Dodge D250 1990 - Page 476

DODGETurbo Diesel
Inspect the Valve Springs
Measure Valve Spring Force
Cylinder Head Removal
Cylinder Head Repair Tools
Daily Maintenance
Coolant recovery tank coolant level - Check .
Cooling system - Check —
Draining fuel/water separator filter
Drive belt - Inspection
Fan - Inspection
Oil level - Check
Radiator coolant level - Check
Drive Belt - Replacement .........
Drive Line/Slip Spline - Recommended Lubricant
Electric Fuel Shut Off Valve - Replacement .....
Electric Fuel Shut Off Valve - Replacement
Electrical - Specifications
Electrical System - Diagnosing Malfunctions
Alternator
Abnormal Ammeter Operation
Coolant Heater - Check
Fuel Shut off Valve - Check
Oil Pressure Switch and Temperature Sensor
Coolant Temperature Sensor - Check ..
Oil Pressure Switch/Sending Unit - Check
Starting Motor
Engine Cranking Speed Too Slow
Engine Does Not Crank
Switch On, Negative (-) on Ammeter, Engine Running.
Abnormal Charging System Operation
Electrical System Description/Operation —
Alternator
Electrical System Specifications
Intake Manifold Heater System
Message Center and Run Circuit
Starting Motor
Emission Control System - •
25-1
Engine Block Water Heater - Replacement 8-19
Engine Component Torque Value 9L-4
Engine Diagrams •
0D
~
2
Air System OD-2
Cooling System • OD-3
Fuel System •
0D
*
2
Lubricating Oil System OD-3
Lubrication for the Overhead — OD-5
Lubrication for the Power Components OD-4
Lubrication for the Turbocharger — OD-4
Engine Idling • OB-9
Engine Lubricants (During Assembly) 9L-S
Engine Oil - Recommended • OH-2
Engine Removal - Procedure - • •
Engine Replacement - Procedure
Engine Sealants (During Assembly) 9L-7
Engine Specifications 9L-9
Engine Testing • - • • •
Blowby Conversion Chart (5.613 mm [0.221 in] Orifice) 9J-8
Blowby Limits 9J-7
Blowby Measurement 9J-7
Engine Rating • 9J-9
Index
Page 3
9F-20
9F-20
9F-9
9K-16
OC-4
OC-4
OC-4
OC-5
OC-5
OC-5
OC-4
OC-5
7- 10
OH-2
14-26
8- 14
8-25
8-6
8-8
8-9
8-11
8-10
8-10
8-11
8-11
8-6
8-8
8-6
8-9
8-9
8-2
8-3
8-6
8-4
8-5
8-2