DOGA DPC TOUCH V2 - Page 3

User manual DPC Touch V2 DOC.60352-11/20
3
3.4.1 Encoders - Tolerances Channel 1 to 4......................................................25
3.4.2 Encoders - Position Pick up 1 & 2............................................................. 25
3.4.3 Encoders - Encoder Reference Point / Zero position............................. 27
3.4.4 Encoders - Rest Position............................................................................ 27
3.5 Controller Parameters - Inputs.................................................................28
3.6 Controller Parameters - Outputs..............................................................31
3.7 Controller Parameters - Network............................................................. 33
3.7.1 Network - RS-232 - Serial Communication.............................................. 33
3.7.2 Network - Ethernet Communication - Modbus TCP/IP...........................34
3.7.3 Network - Barcodes..................................................................................... 35
3.7.4 Network - Barcode filtering rules (start/ end) job call:............................ 36
3.8 Controller Parameters - Others................................................................37
3.8.1 Others - Real time encoders monitoring...................................................37
3.8.2 Others - Input monitoring............................................................................ 37
3.8.3 Others - Outputs test................................................................................... 37
3.8.4 Others - Touch Screen Calibration............................................................ 37
3.8.5 Others - Sounds........................................................................................... 37
3.8.6 Others - Date & time.................................................................................... 38
3.8.7 Others - Languages..................................................................................... 38
3.8.8 Others - Change Password........................................................................ 39
3.8.9 Others - Reset to factory settings.............................................................. 39
3.8.10 Others - Firmware Version........................................................................39
4. USE............................................................................................................40
4.1 Tool Start-Up and Stop.............................................................................. 40
4.2 Main Menu...................................................................................................40
4.3 Menu - Operation Mode............................................................................ 41
4.4 Menu - Job Manager................................................................................. 42
4.4.1 New job creation...........................................................................................43
4.4.2 Fastening step creation............................................................................... 45
4.4.3 Manual programming of fastening step (DC Tool).................................. 49
4.4.4 Automatic programming of fastening step (GX/GY)............................... 50
4.4.5 Picture programming into a fastening step.............................................. 51
4.4.6 Smart Tolerance detection feature.............................................................52