DOGA DPC TOUCH V2 - Encoders - Encoder Reference Point; Zero Position; Encoders - Rest Position

User manual DPC Touch V2 DOC.60352-11/20
27
3.4.3 Encoders - Encoder Reference Point / Zero position
Encoders’ reference point (or zero position point) can be defined by using this
function. Definition of the reference point is useful when encoders have to be
replaced after failure or when repeatability of position of the workpiece can’t be
assured.
The reference point can be defined by using Pick button or reset by using
Reset button.
The reference point can also be defined by using external input signal in
Operation mode.
3.4.4 Encoders - Rest Position
Designed to make sure the tool is not interfering when the product is moving
along the production line, the rest position can be defined by using Pick button
or reset by using Reset button.
The rest position can also be defined by using external input signal in
Operating mode.
Encoders turn dark blue and output is activated when rest position is reached.