DOGA DPC TOUCH V2 - Operating - Management of Fastening Time

User manual DPC Touch V2 DOC.60352-11/20
21
3.3.3 Operating - Management of fastening time
Parameters
Description
Range
Default
Value
Min fastening
time limit, %
Lower limit of fastening time control in
percentage of actual fastening time
detected during programming.
Information: changes will be
applied only to new jobs,
existing jobs won’t be
affected.
0 - 100
25
Max fastening
time limit, %
Upper limit of fastening time control in
percentage of actual fastening time
detected during programming.
Information: changes will be
applied only to new jobs,
existing jobs won’t be
affected.
0 - 100
25
Start trigger
release time
limit, ms
Fastening time threshold after which
trigger release will be considered as NG
tightening. Error message “Trigger
released before Torque Up” will appear.
0 -
9999
0