- Rotating Atomizer with External Charging
Version:: 07 • As of:: 01/2020
8 Faults
Pos: 57 /INP/ Bell2/08_01 S icherheitsh inweise_Störu ng @ 46\mod_1 4313380664 99_20.docx @ 556499 @ 2 @ 1
8.1 Safety provisions
Repairs to individual components of the product are not approved by
the manufacturer. You may only replace damaged components. The
corresponding spare parts can be found in the Chapter "Spare parts"
If you have any questions about maintenance and repair work or need
assistance in staff training, please contact our training department
(see "Contacts & Hotline").
C A U T I O N
Spare parts that are not approved by Dürr Systems, may not
withstand the loads
Damage and production interruption can result.
Use only original spare parts.
W A R N I N G
Risk from explosive atmospheres
Sparking can cause an explosion.
Before entering the booth, and the use of ground rod no explosive
atmosphere may be present in the booth.
The spray system must be in the "maintenance" mode before entering
the spray booth. Make sure that nobody can switch on the system
again, as long as someone is in the spray booth.
W A R N I N G
Danger from high voltage
Risk of electric shocks and discharges.
First touch atomizer with a grounding rod and discharge before
touching the atomizer.
Always carry out repairs in the workshop.
Remove the defective atomizer and replace it with one which works.
Thus, production can continue and the defective atomizer can be
repaired in the workshop.
To Next Page
Loading...