- Rotating Atomizer with External Charging
Version:: 07 • As of:: 01/2020
4.6.1.1 Case for checking high voltage shutdown
The tool kit is designed for checking atomizers of the 2G category
according to the test run described in the appendix to these operating
instructions.
4.6.1.2 Atomizer attachment 60 ° (elbow)
The elbow is hollow. The hoses run from the flange assembly through
the elbow to the paint supply components. At the front of the elbow
the flange is connected to the hose package. The rear end is fastened
to the atomizer support.
In the elbow “N34850018”, a lid provides access to the inner parts of
the elbow. A push-button control for the activation of the shaft detent
is placed on the lid.
4.6.1.3 Atomizer pickup
The atomizer pickup can be used to mount the atomizer.
4.6.1.4 Clamp for atomizer mount
The
clamp adjusts to the atomizer mount bar. The control valve for the
recirculation can be mounted to the clamp.
4.6.1.5 Manual grounding rod
The manual grounding rod grounds dangerous charges.
• Discharge all components in the paint cell with the grounding rod
before touching them.
• Attach the grounding rod to the atomizer during any maintenance
work on the atomizer, if possible.
4.6.1.6 Assembly bracket for atomizer
The atomizer can be fixed to the assembly bracket in the work shop
for maintenance. Compressed air can be connected to the assembly
bracket.
4.6.1.7 Thread cleaner
The thread cleaner can help to clean dirt from the thread of the hollow
turbine shaft. This is required for the correct assembly of the bell disk
after cleaning and maintenance work.
To Next Page
Loading...