Dorr EcoBell2 SL EC - 9.4.1 Dismantling of the shaft detent; 9.4.2 Installation of the shaft detent

156 pages

To Next Page

To Previous Page

Operating Manual

EcoBell2 SL EC

- Rotating Atomizer with External Charging

Faults

Document No.: MRA00

001EN

Version:: 07 • As of:: 01/2020

125 / 156

9.4.1 Dismantling of the shaft detent

• Unscrew the lid of the shaft detent from the valve block. For this

purpose, use the special tool for fiber optics.

Fig 176: Lid of the shaft detent

1 Lid

2 Special fiber optics tool

• Remove the shaft detent from the body.

Fig. 277: Removing the detent from the body

9.4.2 Installation of the shaft detent

• Lightly grease the O-ring of the shaft detent with special grease

(see chapter 10 in “Auxiliary materials for maintenance”).

• Insert the shaft detent.

• Screw in the lid of the shaft detent with the special fiber optics tool.