Dorr EcoBell2 SL EC - Section 1; Default Chapter; Table of Contents

To Next Page

To Previous Page

Operating Manual

EcoBell2 SL EC

- Rotating Atomizer with External Charging

Document No.: MRA00001EN

Version:: 07 • As of:: 01/2020

3 / 156

TABLE OF CONTENTS

1 Introduction ............................................................................................ 9

1.1 Information about the document .............................................................. 9

1.2 Symbols in the document ......................................................................... 9

1.3 Intended use .......................................................................................... 10

1.4 Avoiding foreseeable misuses ............................................................... 12

1.5 Material numbers ................................................................................... 12

1.6 Device combination ................................................................................ 12

1.6.1 Dürr components needed for the use of the atomizer as 2G device ............... 12

1.6.2 Dürr components needed for the use of the atomizer as 3G device ............... 12

1.6.3 Available device combinations ........................................................................ 13

1.6.3.1 EcoBell2 SL EC ............................................................................................... 13

1.6.3.2 EcoBell2 SL EC with “EcoAUC” control system ............................................. 13

1.6.3.3 Total system EcoRP 10 R1100 ....................................................................... 13

2 Safety .................................................................................................... 13

2.1 Danger zones......................................................................................... 14

2.2 Safety requirements ............................................................................... 16

2.3 ATEX marking ........................................................................................ 16

2.4 Residual risks ......................................................................................... 18

2.4.1 Parameters ...................................................................................................... 18

2.4.2 Operation ......................................................................................................... 18

2.4.3 Maintenance and repair ................................................................................... 18

2.5 Conduct in the event of a hazardous situation ....................................... 19

2.6 Responsibility of the operator................................................................. 19

2.7 Personnel Requirements ....................................................................... 21

2.7.1 Cleaning Staff .................................................................................................. 21

2.7.2 Assembly personnel ........................................................................................ 21

2.7.3 Electrical personnel ......................................................................................... 22

2.7.4 Paint personnel ................................................................................................ 22

2.8 Personal protective equipment............................................................... 22

2.9 Danger of damage to property ............................................................... 25

2.10 Environmental protection ....................................................................... 25

2.11 Emergency shutdown ............................................................................ 25

3 Transport and storage ......................................................................... 26

3.1 Delivery .................................................................................................. 26

3.2 Storage .................................................................................................. 26

3.2.1 Storage of electrode rings and atomizer body ................................................. 26

4 Operating principle .............................................................................. 27

4.1 Brief description ..................................................................................... 27