Dräger Evita 4 - Fitting Temperature Sensor

1 Hang the hinged arm from the rail on the left-hand
side and tighten screws.
● Connect ventilation hoses, and note length of hose
(metres).
2 Turn ports in direction of hoses.
3 Install water traps in vertical position.
● Connect the Y-piece, with the rubber sleeve of the
Y-piece on the inspiratory side.
Fitting temperature sensor
4 Push sensor as far as it will go into the rubber sleeve
on the inspiratory side of the Y-piece. Align the
Y-piece so that the sensor is at the top.
5 Attach the sensor cable with hose clips.
6 Insert the probe of the temperature sensor into the
socket »Temp m« at the rear of the unit.
D
0,6m
0,4m
0,6m
0,4m
0,6m
1
3
2
33
Preparation
Ventilation Adults and Children
4
5
6