Screen freeze
To "freeze" the curves and loops (freezing loops is
optional)
1 Press »Stop« key.
To display the pair of measured values, a point on the
curve or loop:
2 Position the cursor on the relevant point by turning
the rotary knob.
The corresponding pair of measured values is
displayed above and beside the curve.
The Reference key remains disabled as long as the
Freeze function is active.
To display new curves / loops again:
1 Press »Stop« key again.
Screen freeze mode is automatically terminated
3 minutes after the rotary control was last turned.
Operation
Displaying Curves and Measured Values
86
D Evita 4
1
2
To Next Page
Loading...
