Dräger Evita 4 - Positioning the Control Unit; To Position the Control Unit on the Wall Rail; To Position the Control Unit on the Device

Positioning the control unit
● Do not lean the control unit.
When changing, lay it on its back.
To position the control unit on the wall rail
1 Hold down the segments on the right and left, and tilt
the control unit fully downwards.
2 Hold down the release buttons on the left and right,
and remove the control unit from the Evita 4 mounting.
● Uncoil the cable as far as necessary.
● Clip the control unit to the wall rail and
3 lock in place = pull down the latch situated beneath
the bracket and turn it in the direction of the wall rail.
1 Hold down the segments on the right and left and at
the same time tilt the control unit to the desired
position.
To position the control unit on the device
● Hold down the segments on the right and left and tilt
the control unit fully downwards.
● Release the control unit = turn the latch away from the
wall rail and lift the control unit off the rail.
● Coil the cable.
● Hang the control unit in the Evita 4 mounting so that it
rests in position.
● Hold down the segments on the right and left, and at
the same time tilt the control unit to the optimal
position.
1
1
47
Preparation
Positioning the control unit
2
2
3