Dräger Fabius plus - Page 140

Configuration
140 Instructions for use Fabius plus SW 3.n
The screen with the default settings opens.
The following settings can be changed:
– Volume Settings
– Pressure Settings
*
– Pressure Support Settings*
– SIMV/PS Settings*
– Alarm Limits
– Minimum Alarm Volume
– Restore Factory Defaults
 To return to the Standby Set-up screen, select
the input arrow (C) and confirm.
Default settings for Volume Control
1 Select Volume Settings (E) and confirm.
2 Press softkey (F) of the parameter to be
changed.
3 Select new value and confirm.
4 If necessary, repeat steps 2 and 3 for other
parameters.
5 Finally, confirm all changes once again.
The window is closed, the cursor is on the input
arrow (D).
Default settings for Pressure Control, Pressure
Support, and SIMV/PS
 Change the parameters (see description in
section ''Default settings for Volume Control''
on page 140).
22105
*optional
Standby Set-up
C
22111
Standby Set-up
D
E
F