12 | 7. Power
DuraLabel.com | 800.788.5572
7. Power
The Lobo comes with a DC power adaptor and a power cord; these allow the Lobo to be
powered by standard AC outlets. To plug in the Lobo, first plug the power cord into the
DC power adaptor, and then plug the DC adaptor cord into the Lobo. Finally, plug the
power cord into an AC power outlet.
The On/Off switch is located beside the power cord input. Pressing the
will turn the
Lobo on. Pressing the
will turn the Lobo off.
NOTE: When plugging the power cord into the Lobo, always make sure the On/Off
switch is Off.
Power input On/off switch
To Next Page
Loading...
