DuraLabel.com | 800.788.5572
14.2 Upgrading a Driver | 45
PRINTING FROM A COMPUTER
14.2 Upgrading a Driver
If you’re upgrading from a previously installed driver, follow these steps to uninstall the
driver that exists on your computer.
1. Load the Lobo installation CD. (Alternatively, download the printer driver from the
Graphic Products website.)
2. Press the Uninstall Driver button on the startup screen.
3. Click Remove printer driver, then click Next.
4. Click Use advanced printer driver removal options, then click Next.
5. Check all existing DuraLabel printers, then click Next.
6. Check all existing DuraLabel drivers, then click Next.
7. Check all existing DuraLabel components, then click Next.
8. Check the files associated with the deleted items you wish to remove, then
click Next.
9. Review the list provided, then click Finish.
10. Click Restart.
The new Lobo printer driver may now be installed. (Follow directions in the previous
section, Installing printer driver).
NOTE: If upgrading from an older driver, you may need to restart your computer during
installation of the new driver.
Because the Lobo is not an edge-to-edge printer, an unprintable margin exists at both
the top and bottom of the label canvas. To avoid print quality issues, always design
labels with at least ⅛” (3.1 mm) of space at the top and bottom edges of the label.
When your computer prints to the Lobo, its settings may override the internal Lobo
settings. If you change back to using Lobo on its own, unconnected to the computer, you
will need to reset the Lobo settings; simply turn Lobo off and wait at least five seconds
before turning it back on. Then, you will be ready to design and print labels again.
To Next Page
Loading...
