DuraLabel.com | 800.788.5572
3. Safety Instructions | 7
3. Safety Instructions
Please review the following safety instructions before using the Lobo:
• Keep the printer away from humidity and prolonged exposure to direct sunlight. The
Lobo is intended for indoor use only.
• Use the Lobo only with the provided 19V DC power supply, model EA10953.
• Check the power source voltage before connecting the printer to a power outlet.
• Disconnect the printer from the power outlet when not using the printer or charging
the battery.
• Before plugging the power cord into the Lobo, make sure the On/Off switch is set to Off.
• DO NOT pour liquid onto the printer or printer parts.
• ONLY qualified service personnel should attempt to perform maintenance on the printer.
• The printer MUST be turned off before any type of maintenance work is done.
• The Lobo may build a small static charge in static-sensitive environments. Do not
operate the Lobo near flammable materials.
• The power outlet should be near the printer and easily accessible for quick power
disconnection.
• Remove the battery and unplug the printer from the wall socket to completely
disconnect power.
• Never throw the Lobo battery into a fire as it could explode.
• Never disassemble the Lobo battery, as leakage and damage may occur.
• Puncturing the Lobo battery may result in fire.
• Do not step or stand on the Lobo battery.
• Do not bring the Lobo battery terminals into contact with another metal object.
• Do not expose the Lobo battery to any liquid or direct sunlight.
• Do not store the battery in a locked or unventilated vehicle where extreme
temperatures may be experienced.
• Always keep the Lobo battery out of reach of infants or small children.
• Dispose of the Lobo battery in accordance with local regulations regarding
battery disposal.
To Next Page
Loading...
