DuraLabel Lobo - 4 Batteries, Certifications, Declaration of Conformity; Batteries; Certifications; Declaration of Conformity

DuraLabel.com | 800.788.5572 4.3 Declaration of Conformity | 9
4. Batteries, Certications, Declaration
of Conformity
4.1 Batteries
Information for EU-member states only: The following symbol, of a crossed out
wheeled bin indicates that the Lobo battery must be disposed of properly and not
treated as general waste. Incorrect disposal could have a negative impact on human
health and the environment. For more information on the correct disposal/recycling of
this battery, please contact Graphic Products at +1.503.644.5572.
Lobo battery conforms to the following transportation testing and European standards:
This Lithium polymer battery pack has been tested and passed with the requirements of
UN 38.3, IEC 60950-1:2005(2nd Edition) and/or EN 60950-1:2006.
4.2 Certications
FCC Compliance: This equipment has been tested and found to comply with the limits
for a CLASS A digital device, pursuant to Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy,
and if not installed and used in accordance with instructions may cause harmful
interference to radio communications. Changes and modifications could void the user’s
authority to operate this equipment.
• Canada: This device complies with Canada ICES-003 Class A. IC: 10524A-2012003.
• Lobo conforms to the following US, Canadian and European EMC and EMI
standards: This equipment has been tested and passed with the requirements
relating to electromagnetic compliance based on the standards RSS-Gen:2010,
FCC 15.225:2011, ANSI C63.4:2003, EN 60950-1:2006 + A11:2009 + A1:2010 +
A12:2011.
• Lobo CE Eligibility: Eligible to bear
certification mark. See aforementioned bullet
for further details.
4.3 Declaration of Conformity
The Declaration of Conformity can be obtained from:
Graphic Products, Inc.
Engineering Department
6445 SW Fallbrook Place
Beaverton, Oregon 97008 USA
Phone: +1.503.644.5572 | Fax: +1.503.646.0183
info@graphicproducts.com | GraphicProducts.com