DuraLabel.com | 800.788.5572
13.16 Setup | 37
LABEL-EDITING FUNCTION KEYS
13.15 Clear
The Clear function gives you several ways to delete label content:
All Labels: This command erases all labels in the current project. Current format
settings will still be present.
All Labels, Restore Defaults: This erases all labels in the current project. It also erases
any changes you have to the label’s settings, returning them to their default values.
Defaults can be edited through the Setup > Set Defaults menu.
Current Label: This erases only the current label. This allows for the removal of a single
label from a multi-label project.
Current Cell: This erases only the contents of the current cell.
Each of these options is followed by an “Are you sure?” prompt, requiring you to select
Yes before the deletion is completed.
13.16 Setup
The Setup menu allows you to change the following formatting and printing options:
Set Defaults: This menu allows you to edit the default values for many of the settings of
the Lobo, including text formatting, label-cutting preferences, frame preferences, print
preferences, and barcode settings. These edited default settings will be saved on the
Lobo even when power is shut off. To restore the Lobo settings to their factory presets,
use the Factory Reset option at the bottom of the menu.
Auto Cut: There are three available settings for Auto Cut: On, Off, and Mark.
1. On: This is the default setting: it automatically cuts the labels based on what is
chosen in the Cut Mode options: either Every or Batch.
2. Off: This setting turns off label cutting. If Auto Cut is Off, multiple labels will
print out continuously without a separation. If necessary, manual cutting can be
performed by pressing the Cut key.
3. Mark: In this mode, the printer prints marks between labels instead of cutting
between labels. The labels can be manually cut at a later time.
To Next Page
Loading...
