GBK51948 RHINO2
Installation Manual Issue 5
If 1 Hz Data is not enabled, its status information is included in the Full Data packet
instead.
Note
Single wire communications is covered in section 7.7 Status Information — Single Wire Communications.
6.5.8.4 Low Power Mode Duration
Parameter Possible Values Default HHP Lite Std Adv
Low Power Mode Duration
1
0 – 90 days 0
✓
This parameter sets the number of days the controller remains in Low Power Mode.
For more information about Low Power Mode, see 5.11 Controller Power Modes.
1
Low power mode is only available in firmware supporting DFVN 6. Program revisions and software versions are detailed in
the table in section 6.2.1 Software version and module version.
Page 112 - Programming
To Next Page
Loading...
