GBK51948 RHINO2
Installation Manual Issue 5
6.2 Dynamic Wizard
The PC-based Dynamic Wizard provides access to all the parameters that are allowed to be
edited or seen based on the dongle level. In addition, the Wizard can also generate
comprehensive diagnostics reports. For more information, see the Wizard user manual.
6.2.1 Software version and module version
Some parameters are only available to specific module versions or program revisions. Each
software version will support only one program revision.
You can check the software version of your controller with:
l
the main screen of the HHP (see 6.1 The Hand Held Programmer (HHP) ).
l
the Wizard: Read Diagnostics. The software version is in the System Information
section.
You can check the module version of your program with:
l
the Wizard Tools -> Change Module Version.
The relation between program revision and software version is shown below:
Program revision Software version
DFVN 0 Not available
DFVN 1 0.08 – 1.01
DFVN 2 1.02 – 1.09
DFVN 3 1.10 – 1.17
DFVN 4 1.18 – 1.19
DFVN 5 1.20 – 1.28
DFVN 6 1.29 – and higher
Page 64 - Programming