l
For learner drivers, set the drive performance parameters, such as the maximum
speed, acceleration and deceleration rates (see section 6.5.3 Drive Performance) to
suit their ability.
l
It is the responsibility of the OEM and installer to make sure that the maximum
driving speed of the vehicle is limited as appropriate when the vehicle is in a
mechanically unstable position, for example when the seat is raised.
l
It is the responsibility of the therapist/installer to minimise any risk of use error,
including those arising from ergonomic features and/or the environment in which the
device is intended to be used
l
After configuring the system with either the DX-HHP hand-held programmer or the
PC-based Wizard programmer, make sure:
o
the programming has completed correctly and verify that the program has
written as requested;
o
vehicle safety is tested;
o
the user is capable of understanding and driving the vehicle.
8.8 Electromagnetic Compatibility (EMC)
Dynamic Controls Electronic Controllers have been tested on typical vehicles to confirm
compliance with the following appropriate EMC standards:
USA: ANSI/RESNA WC-2:2009 Sec 21
Europe: EN 12184: 2014 12.1
National and international directives require confirmation of compliance on particular
vehicles. Since EMC is dependent on a particular installation, each variation must be tested.
The guidelines in this section are written to assist with meeting EMC requirements in
general.
8.8.1 Minimising Emissions
To minimise emissions and to maximise the immunity to radiated fields and ESD, follow the
General Wiring Recommendations in section 5.3.1 of this manual.
8.9 Environmental statement
Dynamic Controls confirms that the product variants specified in this manual, as sub-
assemblies of electronic and electrical equipment supplied for further integration by a
medical device manufacturer, conform to applicable requirements of Directive
2011/65/EU, recast of Directive 2002/95/EC - Restriction of the use of certain Hazardous
Substances in electrical and electronic equipment.
GBK51948 RHINO2
Installation Manual Issue 5
Appendices - Page 151
To Next Page
Loading...
Need help?
General
