Dynamic RHINO2 DS90 User Manual

2 Contents
1 About this manual 1
2 Contents 3
3 Introduction 7
3.1 Rhino2 overview 8
3.2 Rhino2 features 8
4 Specifications 11
4.1 Electrical Specifications 12
4.2 Physical Specifications 14
5 Installation and testing 15
5.1 Mounting 16
5.1.1 General Mounting Conditions 16
5.1.2 Mounting Orientation 17
5.2 Attaching the terminal cover 19
5.3 Connections and Wiring 20
5.3.1 General Wiring Recommendations 20
5.3.2 Wiring Diagram for DS90 and DS120 22
5.3.3 Wiring Diagram for DS160 and DS180 22
5.4 Battery Connections 23
5.5 Motor Connections 25
5.5.1 Motor Protection 26
5.5.2 Motor Testing 26
5.6 Park Brake Connections 27
5.6.1 Park Brake Testing 29
5.7 Battery Charging and Programming Connections 29
5.7.1 Battery charger connections 30
5.7.2 Programmer Connections 32
5.7.3 External Ambient Temperature Sensor Connection 33
5.8 Tiller Connector 34
5.9 Throttle Configuration 35
5.9.1 Protection against open-circuit, short-circuit and leakage current 35
5.9.2 Single throttle wiper 36
5.9.3 Neutral Detect 37
5.9.4 Two throttle wipers - mirrored 40
5.9.5 Throttle Calibration 40
5.9.6 Speed Limit Pot Connections 41
5.9.7 Alternative Speed Reduction Options 42
5.9.8 Tiller Battery Supply 44
5.9.9 Key Switch Input 45
5.9.10 Status Indicator Output 45
5.9.11 Beeper Output 46
5.9.12 Battery Gauge Output 46
5.9.13 Brake and Reversing Lights 47
5.10 Multifunction Pins 48
5.10.1 Multifunction Inputs 48
GBK51948 RHINO2
Installation Manual Issue 5
Contents - Page 3

Dynamic RHINO2 DS90 Specifications

General

Brand	Dynamic
Model	RHINO2 DS90
Category	Controller
Language	English