GBK51948 RHINO2
Installation Manual Issue 5
8.4 Service life
If the product has not been abused and all maintenance instructions as described in the
maintenance section have been properly followed, the expected service life (i.e. minimum
serviceable life expectancy) of the product is five (5) years. After this period, product
reliability can no longer be guaranteed and Dynamic Controls recommends the product be
replaced for safety reasons. Dynamic Controls accepts no responsibility/liability for product
failure if the product is continued to be used after the expected service life period has
expired.
Warning
It is the OEM's responsibility to state the expected service life, as well as the inspection and maintenance
schedules for all cables.
8.5 Maintenance
The following instructions must be passed on to the operator before use of the product.
1. Keep all DYNAMIC electronic components free of dust, dirt and liquids. To clean the
product, use a cloth dampened with warm soapy water. Do not use chemicals,
solvents or abrasive cleaners, as this may cause damage to the product.
2. Once a month, check all vehicle components for loose, damaged or corroded
components, such as connectors, terminals, or cables. Restrain all cables to protect
them from damage. Replace damaged components. Check for and remove any
foreign objects or material.
3. Every 6 months, test all switchable functions on the DYNAMIC electronics system to
ensure they function correctly.
4. There are no user-serviceable parts in any DYNAMIC electronic component. Do not
attempt to open any case or undertake any repairs, else warranty will be voided and
the safety of the system may be compromised.
5. Where any doubt exists, consult your nearest service centre or agent.
Warning
It is the responsibility of the end user to maintain the unit in a state of good repair at all times. If any
component is damaged in any way, or if internal damage may have occurred (for example by being dropped),
have it checked by qualified personnel before operating.
8.6 Warranty
All equipment supplied by Dynamic Controls is warranted by the company to be free from
faulty workmanship or materials. If any defect is found within the warranty period, the
company will repair, or at its discretion replace, the equipment without charge for materials
or labour.
This warranty is subject to the provisions that the equipment:
Page 146 - Appendices
To Next Page
Loading...
Need help?
General
