GBK51948 RHINO2
Installation Manual Issue 5
8.7.2 Service and Configuration Warnings / Notices
The following warnings and notices are applicable to the installation technician and the
dealer or the therapist who supplies the vehicle to the end user.
Warning
The dealer, therapist or other agent who supplies the vehicle to the end user has the responsibility to make sure
that the vehicle is correctly configured for the needs of that user.
Warning
For each individual user, the vehicle set up and configuration should take into consideration his or her:
o
technical knowledge, experience and education, and
o
medical and physical condition, including the level of disability and capability (where applicable).
Warning
Prior to handing over the vehicle, make sure that users are fully able to operate the product by giving them
appropriate training on functionality and safety features, and having them test-drive the vehicle in a safe area
in the presence of their agent.
Warning
The controller can cause the vehicle to come to a sudden stop. If this can be dangerous to the operator, the
installer must install a seat belt and the operator must wear this belt.
Note
It is the responsibility of the manufacturer, dealer, therapist, or other suitably trained personnel, to determine
the most appropriate installation suitable for any single user.
l
It is the responsibility of the installer to make sure that accessories that are
connected to the wires of the vehicle do not interfere with the operation of the
controller.
l
Do not use the vehicle frame as the earth return. Any electrical low-resistance
connection to the frame is a safety risk and is not allowed by international safety
standards.
l
If the vehicle loses electric power, it is important that an attendant is able to move
the vehicle easily.
l
After you have completed the installation, check it thoroughly. Correctly adjust all
programmable options before the vehicle is used.
l
After you have configured the vehicle, check to make sure that the vehicle performs
to the specifications entered in the programming procedure. If the vehicle does not
perform to specifications, reprogram it. Repeat this procedure until the vehicle
performs to specifications. If the wanted operation cannot be reached, contact your
service agent.
l
After maintenance or service of the vehicle, check the functional operation of all
components that are externally connected to the controller, such as:
o
lights
o
external switches
o
DCI/ACI/OBC resistor switch circuits
(including programmed slowdown behaviour)
Page 150 - Appendices
To Next Page
Loading...
Need help?
General
