Parameter Description
Min Nominal Max Units
l
Boost Current
20 A
l
Boosted Current
200 A
l
Boost Time
5 s
Park Brake Output
l
Voltage
24 V
l
Current
1.25 A
Note 1:
The RHINO2 transitions to Limp Mode when the battery voltage falls below its cut-off voltage or exceeds 30 V. During Limp
Mode, the scooter can continue to be driven, albeit at a reduced speed. If, while driving, the voltage drops below 17 V for more
than 4 seconds or rises above 33 V for more than 4 seconds, the scooter will slow down to a stop. Driving can resume once the
battery voltage is restored to within an acceptable voltage range, 21-29 V. If, while driving, the battery voltage rises to 35 V or
above, a slam stop will be invoked to prevent the battery being damaged.
Warning
The peak currents indicated above are based on when Stall Timeout is set to zero (that is, the stall timer is
disabled). The installer must ensure that the scooter’s wiring, connectors, and motor are suitable for these high
currents for this time period. The stall timer should never be disabled during normal operation.
GBK51948 RHINO2
Installation Manual Issue 5
Specifications - Page 13
To Next Page
Loading...
Need help?
General
