GBK51948 RHINO2
Installation Manual Issue 5
The RHINO2 is programmed during manufacture with default settings. Modify these settings
with a programmer to suit a specific scooter model or end user. The RHINO2 can be
programmed with two different programming tools:
l
The DX-HHP hand-held programmer (see 6.1 The Hand Held Programmer (HHP) )
l
The PC-based Wizard programmer (see 6.2 Dynamic Wizard)
Warning
No matter which programmer is used, after configuring the system, make sure:
l
the programming has completed correctly and verify that the program has written as requested;
l
vehicle safety is tested;
l
the user is capable of understanding and driving the vehicle.
Two different programming sockets can be used to program the RHINO2:
l
The standard 3-pin XLR-type Battery Charger socket (if available on the scooter)
l
The Charger/Programmer socket on the RHINO2 itself.
Figure 31: Programming Adaptor
Programming socket Adaptors needed
XLR Charger socket DWIZ-ADAPT
Charger/Programmer socket DWIZ-ADAPT + DR-PRGLM02
Page 56 - Programming
To Next Page
Loading...
Need help?
General
